CAMPLATE TOOL

Replacement gasket for FEULING tool #9010

#9010 Pressure test tool is a must for any H-D Twin Cam engine builder. Bench test each camplate before installation, cycle the pressure relief valve, testing operation and assuring the valve moves freely, seats and seals each time, any leakage at the relief valve will reduce oil pressure.

This tool allows the engine builder to know what PSI the relief valve opens; the spring tension can be adjusted to achieve the desired pop off PSI. Tool includes: air regulator, 0 - 100 psi pressure gauge, gasket & needed hardware, fits all Twin Cam engine camplates. Feuling recommends the camplate valve be seated 0-30 psi with full pop off at 55-60 psi. Made in the U.S.A.

Part # 9011 Replacement gasket for tool #9010

FITS:

Pressure test Twin Cam camplates on the bench prior to installation, verify the valve seats and seals and the pop off pressure. Fits all TC camplates factory and aftermarket, 07-17 camplates will have 1 un-used bolt hole

COUNTRY OF ORIGIN:

USA

Disclaimer: Qualified Manufacturer Declared Replacement Part means any aftermarket part intended to replace an original equipment emissions related part and which is functionally identical to the original equipment part in all respects which in any way affect emissions (including durability), or a consolidated part, that has been evaluated and declared by the manufacturer to meet this definition and carry this categorization and designation label. This manufacturer has declared in writing that it has documentation, based upon sound engineering judgment, indicating the replacement part does not reduce the effectiveness of any required emission control device and it does not cause the modified vehicle/engine/equipment to exceed applicable emissions standards for that make/model/year fitment(s) advertised.