FEULING M8 OIL PUMP PSI TESTER

M8 FEULING OIL PUMP PSI TESTER

$379.95
In stock
9006

FEULING oil pump pressure test tool for Feuling M8 oil pumps


Part#: 3801-0328
  • FEULING oil pump pressure test tool for Feuling M8 oil pumps, ONLY fits FEULING oil pumps, does not fit factory HD oil pumps.
    Bench test the FEULING Milwaukee Eight oil pumps, cycle the pressure relief valve, testing operation and assuring the valve moves freely, seats and seals each time, any leakage at the relief valve will reduce oil pressure.
    FEULING oil pump pressure test tool for Feuling M8 oil pumps, ONLY fits FEULING oil pumps, does not fit factory HD oil pumps.
    This tool allows the engine builder to know what PSI the relief valve opens; the spring tension can be adjusted to achieve the desired pop off PSI. Tool includes: air regulator, 0 - 100 psi pressure gauge, plugs for water and oil cooled oil pumps, gasket & needed hardware. Feuling recommends the oil pump relief valve be seated and sealed from 0-30 psi with full pop off at 50-60 psi. Made in the U.S.A.

    Proper relief valve seal will insure good hot idle oil psi and reduce oiling system cavitation and related pressure issues.
    Fits Feuling oil and center/water cooled oil pumps 7018, 7019, 7020, 7021
    Does not fit Factory HD oil pumps


    FITS:

    M8 17-25 FEULING oil pump ONLY, fits Feuling oil and center/water cooled oil pumps 7018, 7019, 7020, 7021


    COUNTRY OF ORIGIN:

    USA

    Disclaimer: Qualified Manufacturer Declared Replacement Part means any aftermarket part intended to replace an original equipment emissions related part and which is functionally identical to the original equipment part in all respects which in any way affect emissions (including durability), or a consolidated part, that has been evaluated and declared by the manufacturer to meet this definition and carry this categorization and designation label. This manufacturer has declared in writing that it has documentation, based upon sound engineering judgment, indicating the replacement part does not reduce the effectiveness of any required emission control device and it does not cause the modified vehicle/engine/equipment to exceed applicable emissions standards for that make/model/year fitment(s) advertised.

  • Our Dealers / Distributors Part #
    Drag Specialties 3801-0328
    Neo Factory 027142
    Parts Canada Development Co 3801-0328
    Parts Europe 3801-0328

  • 1 HANDLEBAR PSI GAUGE MOUNT - RAW
    Raw mount fits 1 BARS, GAUGE WITH 1/8 NPT PORT

    $ 119.95

    GEAR CROSS WRENCH LOGO POINTS COVER
    TC 99 - 17, 5 hole, FEULING Gear Cross Wrench Logo -...

    $ 69.95

    GEAR CROSS WRENCH DERBY COVER
    99 - 18 Big Twin (Excluding 15 Ultra/Limited, 18 FLSB,...

    $ 139.95

    FEULING Throttle Position Sensor
    Throttle Position Sensor fits TC 06-17 DYNA, FXST, FLST,...

    $ 54.95