Supplemental kit for Milwaukee Eight Cam Kits & Camchest kits.
Includes: #4030 Lifter cuffs, #8070 Tensioner pad/pin and #8041 camshaft alignment spacers.
Add this to your M8 camchest kit to further freshen up the engine and ease install!
• FEULING Lifter cuffs are injection molded Glass-Filled Nylon with Teflon® adder to increase wear and friction resistance. Stronger than factory replacements with added friction reducer.
• Developed due to billet lifter cuffs being found to cause debris and harmonics due to rubbing on the steel lifter flats. Billet cuffs allow excessive lifter rotation/rocking which can lead to axle/roller failure as the lifter is naturally trying to roll off the camshaft lobe. Only takes a few degress of rotation for the lifter roller to stop spinning.
• Increased clearances for larger lift camshafts. Able to use with up to our 618 camshaft without modification. Factory allows up to ~0.540" lift.
• Recommended to be used with FEULING lifters as they fit the tightest, however other branded lifters are compatable. Lifter should have a light slip to snug fit in cuff.
• Includes ARP fasteners and wedge lock washers. Torque bolts to 96in/lbs with Red Loctite.
• Made in USA
• Important install note: Lifter cuff may hold lifter upward. Be sure to firmly push down on lifter to ensure it is on the camshaft prior to installing/adjusting pushrods. Torque to 96in/lbs with Red Loctite.
• #8070 FEULING Replacment chain tensioner pad and pin. Works with the factory aluminum housing and hydraulic unit, includes pad, retaining pin and button head screws. Pads are injection molded Nylon with Teflon adder to increase wear and friction resistance.
• Made in USA
• #8041 Camshaft sprocket spacing alignment/thrust washer kit. Alignment washers are used to align the rear camshaft sprocket with the crank sprocket to achieve correct chain alignment. Kit includes 0.100", 0.110", 0.120", 0.130", 0.140", 0.150" washers.
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov