FEULING® ENDURANCE BEEHIVE® valve springs allow up to .565” lift camshafts no spring seat machining required. Machined from a premium grade Hi-tensile chrome silicon single conical ovate wire, shot-peened with a specially processed thermal heat treat and super NexTex® finish to give these valve springs the needed fatigue life to exceed the high demands of V-Twin engines from stock to performance.
Don’t get stung by inferior valve springs!
Quicker Revving - Smoother Motion - Less Harmonics
FEULING® BEEHIVE® valve spring kits are each hand measured and labeled specifically based on their coil bind / required open height. Our kits require you to measure installed height and may require use of included shims. This is so you can set up the springs specifically to your camshaft lift for quieter and smoother performance. Similar to tuning your suspension to your weight and riding style.
• FEULING® Endurance springs allow up to .565” cam lift no machining or rocker box clearancing required. FEULING HIGH LOAD springs are good up to .650" cam lift.
• Eliminate valve spring separation, maximize stability, reduce valve-train noise & harmonics!
Kits include: FEULING® ENDURACE BEEHIVE® valve springs, machined spring seats, seat shims, valve locks and a set of premium Viton® valve seals equipped with a spring loaded valve stem wiper system. THIS KIT USES THE FACTORY STOCK STEEL RETAINERS, if Ti retainers are desired see spring kit #1108 or Ti retainer kit #1109
MILWAUKEE EIGHT
SEAT Lbs. / INSTALLED HEIGHT
134 Lbs. @ 1.375” (0.405” Lift)
127 Lbs. @ 1.405” (0.435” Lift)
125 Lbs. @ 1.415” (0.445” Lift)
121 Lbs. @ 1.435” (0.465” Lift)
116 Lbs. @ 1.455” (0.485” Lift)
113 Lbs. @ 1.470” (0.500” Lift)
109 Lbs. @ 1.490” (0.520” Lift)
103 Lbs. @ 1.520” (0.550” Lift)
226 Lbs @ 0.970” OPEN HEIGHT
Coil Bind @ .920
*Cam specs measured on the lifter @ 0.050" lift with 1.61 rocker arm ratio
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Disclaimer:
“Qualified Manufacturer Declared Replacement Part” means any aftermarket part intended to replace an original equipment emissions related part and which is functionally identical to the original equipment part in all respects which in any way affect emissions (including durability), or a consolidated part, that has been evaluated and declared by the manufacturer to meet this definition and carry this categorization and designation label. This manufacturer has declared in writing that it has documentation, based upon sound engineering judgment, indicating the replacement part does not reduce the effectiveness of any required emission control device and it does not cause the modified vehicle/engine/equipment to exceed applicable emissions standards for that make/model/year fitment(s) advertised.
| Our Dealers / Distributors |
Part # |
| LeMans Corporation |
0926-2973 |
| Neo Factory |
033596 |
| Parts Canada Development Co |
0926-2973 |
| Parts Europe |
0926-2973 |
