FEULING LIFTER CUFFS

FEULING Lifter cuffs are injection molded Glass-Filled Nylon with Teflon adder to increase wear and friction resistance. Stronger than factory replacements with added friction reducer.
Developed due to billet lifter cuffs being found to cause debris and harmonics due to rubbing on the steel lifter flats. Billet cuffs allow excessive lifter rotation/rocking which can lead to axle/roller failure as the lifter is naturally trying to roll off the camshaft lobe. Only takes a few degress of rotation for the lifter roller to stop spinning.
Increased clearances for larger lift camshafts. Able to use with up to our 618 camshaft without modification. Factory allows up to ~0.540 lift.
Recommended to be used with FEULING lifters as they fit the tightest, however other branded lifters are compatable. Lifter should have a light slip to snug fit in cuff.
Includes ARP fasteners and wedge lock washers.
Made in USA

FITS:

Milwaukee Eight Engines 17-26

COUNTRY OF ORIGIN:

USA

Disclaimer: Qualified Manufacturer Declared Replacement Part means any aftermarket part intended to replace an original equipment emissions related part and which is functionally identical to the original equipment part in all respects which in any way affect emissions (including durability), or a consolidated part, that has been evaluated and declared by the manufacturer to meet this definition and carry this categorization and designation label. This manufacturer has declared in writing that it has documentation, based upon sound engineering judgment, indicating the replacement part does not reduce the effectiveness of any required emission control device and it does not cause the modified vehicle/engine/equipment to exceed applicable emissions standards for that make/model/year fitment(s) advertised.